|
1.Check if 10/100BaseT wire is correctly
installed between WinClient machine
and the hub.
2.Check with administrator if the
Server IP address is correct.
3.If Server computer name or domain
name is desired instead of specific
IP address in creating connection,
make sure that you have entered the
correct DNS or WINS server if you
choose manual IP, or your NT server
supply appropriate DNS or WINS server
if you choose DHCP.
4.Make sure the hub is functioning.
5.If DHCP is used, check if DHCP
Server in server side has run out
of its IP allocations. If the CE image
version is 1.1f or higher, try to
set to manual IP at Terminal Properties,
click Apply button, reselect DHCP,
click OK, then reboot to see if this
problem is solved. Otherwise, reset
flash memory to factory default and
re-setup the device setting. Refer
to WBT User's Manual for how to reset
flash memory for settings.
6.If manual IP is used, check with
administrator if the assigned IP is
qualified.
7.Power off WinClient machine and
then power on again.
8.Clear all settings in flash by
following the instruction described
in WinClient User's Manual.
|
